Design Validation

CIMTEK's Design Validation test systems come from over 20 years of delivering high quality, high functionality and ROA to the electronics industry. Our environmental testing platforms perform parametric testing on the customer's products at temperature, humidity and other environmental extremes. Our systems can control and monitor a chamber or chambers while simultaneously operating and testing several products in parallel. In addition, CIMTEK provides manufacturing floor "burn in" systems for in-process manufacturing to aid in fault detection or product quality improvement.

• Customized per-product loads (simulated or actual)
• High current (over 80Amps continuous) per pin as needed
• AT-product monitoring of voltages, currents reducing losses
• Coordinated alarm conditions 
• Chamber Profiles specific to each device or test
• Synchronized operations based on profile or segment
• Multiple products tested and verified at the same time (over 40 per chamber)
• Flexible Load Box platform for easy changeover and maximum use of the equipment
• Simple and flexible operations
• Independent communication and control of each product nest
• Control over Thermotron, Watlow, Russells, Cincinatti Sub Zero and many other chamber types
• Low cost manufacturing floor system available as heat only

CIMTEK designs and builds these environmental test systems to ensure verification and qualification of the customer's product during design validation.